OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: scrapheap on October 26, 2006, 05:34:29 am

Title: How Do I Access A Usb Flash Drive?
Post by: scrapheap on October 26, 2006, 05:34:29 am

I have just installed openzaurus (GPE version) and I can't seem to access my USB flash drive.  I have checked and it doesn't want too much power.

Should I have an sda shown in my /dev/ as I don't have any to mount and when I try to modprobe sd I get FATAL: Module sd not found.

Title: How Do I Access A Usb Flash Drive?
Post by: CoreDump on October 26, 2006, 06:28:20 am

Quote

I have just installed openzaurus (GPE version) and I can't seem to access my USB flash drive.  I have checked and it doesn't want too much power.

Should I have an sda shown in my /dev/ as I don't have any to mount and when I try to modprobe sd I get FATAL: Module sd not found.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=144869\"][{POST_SNAPBACK}][/a][/div]

IIRC the modules are part of the default images and any USB storage device should auto-mount (media/sda*).

Title: How Do I Access A Usb Flash Drive?
Post by: scrapheap on October 26, 2006, 09:25:01 am

Quote

IIRC the modules are part of the default images and any USB storage device should auto-mount (media/sda*).
[div align=\"right\"][a href=\"index.php?act=findpost&pid=144871\"][{POST_SNAPBACK}][/a][/div]

I have got modprobe working (It was sd_mod I needed not sd) but my zaurus still doesn't auto detect my usb flash drive.

dmesg shows the following lines when I plug in my usb flash drive

usb 1-2: new full speed USB device using pxa27x-ochi and address 3
usb 1-2: no configuration chosen from 1 choice