OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: Snake on April 06, 2007, 06:47:37 am

Title: Wait... 5
Post by: Snake on April 06, 2007, 06:47:37 am

Hi!

After the last reboot my Z show the startup image after the first "Wait... 5" sequence. Instead of that I get another "Wait... 5" sequence and another too... and so on. After 10 waits there comes a little pause and the shows starts again.

How can I start the Z normaly again? Can I interrupt the boot sequence to edit the files like qpe.sh?

Frank

Title: Wait... 5
Post by: Snake on April 06, 2007, 12:30:24 pm

Okay, If I press "/" on the "Wait... 5" sequence I can choose a console to start, nice.
But If I'm right, the boot problem is before the qpe.sh is running. So how can I fix it to start Qtopia normaly? But how can find out where the problem is?

thx
Frank

Title: Wait... 5
Post by: Snake on April 06, 2007, 02:01:43 pm

Well, the Z is back! :-)

Because a fault of options I have started to remove the last programs I had installed. After removing zstyle-c3000 the GUI was back.

What a    shock! ;-)

Regards,
Frank

Title: Wait... 5
Post by: koan on April 07, 2007, 05:27:43 am

Quote

After the last reboot my Z show the startup image after the first "Wait... 5" sequence. Instead of that I get another "Wait... 5" sequence and another too... and so on. After 10 waits there comes a little pause and the shows starts again.

FYI: That says "Please wait 5 minutes" in Japanese.