OESF Portables Forum
Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Debian => Topic started by: jpmatrix on December 09, 2007, 05:52:18 pm
-
just a little poll to see under which model of zaurus your debian run.
EDITED: Poll results, up to zogs :
-
oups i think i missed the poll
anyway :
C3000 - Debian Sid OK - Kernel 2.6.23 of Angstrom
-
C1000 - Debian Sid OK - Kernel 2.6.22 Y
C3100 - Debian Sid OK - Kernel 2.6.23.9 Y
-
C3100 - Debian EABI 2.6.23.9 Yonggun
-
C1000, Debian EABI, Kernel 2.6.22 Y
-
3100, debian sid eabi, cortez' kernel (opened hand), v 2.6.23
-
C 1000, Debian EABI, Kernel 2.6.22 Y
-
C3200, Debian eabi, kernel 2.6.23.9 Y
-
As in my sig: 3200, cortez-debian, 2.6.23, lenny/sid.
P.S. Thinking seriously about going back to Titchy/OABI and trying to make it work with the OABI kernel and modules that cortez produced, Hoping for EABI to be installable as easily as Titchy and without u-boot.
-
so far, please look in the first post for poll results
-
C3100 : Debian EABI (Sid) 2.6.22.9-Yonggun
-
C3200, Debian eabi, kernel 2.6.23.9
-
first post updated.
that's terrible how many (working!) combination there are out there
-
C 1000, Debian EABI, Kernel 2.6.22.9 Y
-
c3100 2.6.23 eabi
-
C3200 2.6.23.9-yonggun, EABI
C860 2.6.21 (angstrom), EABI
-
C860 2.6.21 (angstrom), EABI
-
Thanks to zdevil, jpmatrix's post(s) and this forum...
C3000 - Debian Sid OK - Kernel 2.6.23 of Angstrom
thx, been a long time since I had this much fun with my Z :-)
-
C1000, Debian EABI, Kernel 2.6.24-yonggun (finally , yonggun kernel without needing u-boot)
-
Sorry for the maybe stupid question,
but how do i boot yongun kernel without uboot? Is there a chance for pdaxrom and Debian?
-
but how do i boot yongun kernel without uboot? Is there a chance for pdaxrom and Debian?
20r0 compiled kernel 2.6.24 for both UBOOT and Sharp Bootloader
The files can be downloaded at http://yonggun.tistory.com/66 (http://yonggun.tistory.com/66)
I can see from your previous posts that you have a C1000.
Assuming you want to install debian on the first partition of your sd card, you should download zImage.bin.mmcblk0p1 and flash the kernel (reboot while holding <ok>, ...)
Don't forget to get the modules-2.6.24-yonggun.tar.gz from the same site and extract it in your root folder after flashing.
Then on first boot afte flashing :
#depmod -a
then reboot.
Confirmed works on C1000 (havent tested sound yet).
After installation, Zaurus boots into sd first partition (assuming you download zImage.bin.mmcblk0p1)
This worked for me but YMMV.