OESF Portables Forum
Everything Else => General Support and Discussion => Zaurus General Forums => Archived Forums => Security and Networking => Topic started by: badllama77 on March 24, 2004, 02:50:12 am
-
Ok at first the light was staying on etc. for the linksys card so I changed the info int wlan-ng.conf removing the version line from the wcf12 section. Now when I run #cardctl ident it identifies it properly, but everytime I try to connect with the gui applet it starts initializes and then almost immediately fails. Anyone seen anything like this
Badllama
-
Found out there were two entries in the wlan-ng.conf, removed the unmodified one and now I am up and running. Now trying to get kismet to work. So far I have created a dummy connection, set up a script to
cardctl scheme CardResume
cardctl scheme qpewlan2 &
kismet_qt
cardctl scheme CardSuspend
The card resumes and suspends on exit, but I get the cannot connect to server message every time.
kismet feb 4.01
kismet-qt 2.0.0
anyone have any clues