OESF Portables Forum

Model Specific Forums => Sharp Zaurus => Zaurus - pdaXrom => Topic started by: datajerk on March 26, 2004, 11:29:04 pm

Title: libstd++
Post by: datajerk on March 26, 2004, 11:29:04 pm

Looking for libstd++ for Lord Davon\'s vncclient to run on Xqt.  Searched pdaXrom ipks and also installed glib* from pdaXrom.  No luck.  Thanks.

Title: libstd++
Post by: Foxdie on March 27, 2004, 06:07:08 am

It\'s out there but it\'s VERY difficult to locate (as far as I found out). I ended up going through lots of google results just to find it.

I can\'t remember where I found it in the end, it was on some ARM feed (not Zaurus specific).

Title: libstd++
Post by: ppfundst on March 29, 2004, 08:08:06 am

you have one here:
http://familiar.handhelds.org/familiar/rel...07-fam1_arm.ipk (http://familiar.handhelds.org/familiar/releases/v0.6.2/base/armv4l/libstdc++2.10-glibc2.2_2.95.4-0.010407-fam1_arm.ipk)

Title: libstd++
Post by: LordDavon on March 29, 2004, 08:53:41 am

It is part of one of the packages on sashz feed.  I don\'t recall which one though.

LD