OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: Ian on April 23, 2004, 02:17:20 pm

Title: Aerlink card not working in Cacko ROM 1.21
Post by: Ian on April 23, 2004, 02:17:20 pm

I\'ve been using my Aerlink (SDG Systems) phone card modem thingy to connect to a Sony Ericsson T610 with Cacko 1.20 on my C860; it worked fine.

After upgrading to Cacko 1.21 (with and without the hotfix) I found that I can\'t use it any more. It says \"CF card type serial device is busy\". Can anyone help with this?

I have confirmed the settings and hardware using an SL-6000; it\'s definitely the new ROM which is responsible.

Thanks, Ian.

Title: Aerlink card not working in Cacko ROM 1.21
Post by: maslovsky on April 28, 2004, 06:55:26 am

Quote

I\'ve been using my Aerlink (SDG Systems) phone card modem thingy to connect to a Sony Ericsson T610 with Cacko 1.20 on my C860; it worked fine.

After upgrading to Cacko 1.21 (with and without the hotfix) I found that I can\'t use it any more. It says \"CF card type serial device is busy\". Can anyone help with this?

I have confirmed the settings and hardware using an SL-6000; it\'s definitely the new ROM which is responsible.

Thanks, Ian.

Might be a serial_cs driver. Try to replace it with the one available for download at this site.

http://www.zaurususergroup.com/modules.php...q=getit&lid=183 (http://www.zaurususergroup.com/modules.php?op=modload&name=UpDownload&file=index&req=getit&lid=183)

Title: Aerlink card not working in Cacko ROM 1.21
Post by: cs on May 02, 2004, 04:09:51 pm

Hello!

I had a similar problem with Cacko ROM 1.21 / 1.21a on SL-C750 with a Pretec CompactModem 56k CF modem card
and solved it by removing the following line in \"/etc/pcmcia/serial\":

UART_CONF=\"/etc/bluetooth/uar\"

It seems the default is set for Bluetooth adapters.

Hope it helps,
Christian

Title: Aerlink card not working in Cacko ROM 1.21
Post by: Ian on May 17, 2004, 11:15:50 pm

Quote

Might be a serial_cs driver. Try to replace it with the one available for download at this site.

Thanks for the suggestion, Maslovsky... I looked at that but it looked too complicated for me, sorry. I have only a small amount of tie for hacking my Zaurus. I do appreciate your reply (and also the Cacko ROM, which is outstanding). Thanks.

Quote

I had a similar problem with Cacko ROM 1.21 / 1.21a on SL-C750 with a Pretec CompactModem 56k CF modem card  
and solved it by removing the following line in \"/etc/pcmcia/serial\":  

Hey... That is just about within my threshold. It looks like that fixed it - I will double check tomorrow. After commenting that line out, it gets as far as dialing the modem on the T610. Unfortunately there is no signal where I am but it looks very promising. Thank you very much, I was about to throw the phone into the junk drawer (I only bought it for that project, not really for talking).

I am very impressed, especially considering that was your first post :-). I only hope I can be as helpful to other people.

Regards,   Ian.

Title: Aerlink card not working in Cacko ROM 1.21
Post by: maslovsky on June 03, 2004, 06:30:27 am

BTW, the \"Serial device busy\" issue should be fixed in Hotfix B, which will be released today.