OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Sharp ROMs => Topic started by: lenk on May 02, 2004, 11:43:17 pm

Title: Cacko 1.21 problem with Symbol card? [FIXED]
Post by: lenk on May 02, 2004, 11:43:17 pm

Hi..I just flashed 1.21 onto my C760. I inserted my symbol wifi card and it was detected. Then I went to settings/network and added wireless lan and put my SSID of my router. The card can\'t connect to my router. Any diagnotics I can perform to see what is wrong? Thanks

LK

Title: Cacko 1.21 problem with Symbol card? [FIXED]
Post by: kbranch on May 03, 2004, 01:15:44 am

I\'ve noticed that my Symbol card has problems connecting to a Belkin AP with 64 bit encryption turned on. It works fine an all the other devices I\'ve tried it on and it has no trouble with 128 bit on the Belkin. :roll:

Mine will act like it can\'t see any signal (relatively long flashes of the LED every second or so), do a few short flashes like it found something, and then just stop trying.

I don\'t know if it would cause a problem or not, but if you\'re not running encryption you don\'t need to specify the SSID.

Title: Cacko 1.21 problem with Symbol card? [FIXED]
Post by: lenk on May 03, 2004, 06:54:20 pm

My router doesnt have WEP or WAP enable. Anyone have same problem? Thanks

Title: Cacko 1.21 problem with Symbol card? [FIXED]
Post by: lenk on May 07, 2004, 05:36:07 am

Any help?

Title: Cacko 1.21 problem with Symbol card? [FIXED]
Post by: lenk on May 07, 2004, 05:58:15 am

I tried iwconfig, it says lo no wireless extensions and eth0 no wireless extension. lsmod shows me that spectrum_cs, orinoco, hermes drivers are loaded. Any idea why I can\'t connect?