OESF Portables Forum

Everything Else => General Support and Discussion => Zaurus General Forums => Archived Forums => Security and Networking => Topic started by: charlesa on June 10, 2004, 03:25:39 pm

Title: Kismet source= config question
Post by: charlesa on June 10, 2004, 03:25:39 pm

Is there an overview doc that anyone can recommend for Kismet source= configuration?  I have spent many an hour looking thru the faq and other sources here, but can\'t seem to pin down the necessary syntax.

Here is the message I am getting when running kismet_server (v3.1.0) under Cacko121 with a DLink660W card:

FATAL: Unknown capture source type \'prism2_cs\' in source \'prism2_cs,eth0,prism2source\'

My /home/etc/pcmcia/wlan-ng.conf tells me that the Dlink card is prism2_cs but I have tried that plus other prism2 iterations such as prism2, and prism2legacy.  All result in the FATAL error.

Also following the HOWTO doc (http://www.zaurususergroup.com/modules.php?op=modload&name=phpWiki&file=index&pagename=Kismet%20Working%20on%203.10%20ROM) but I can\'t seem to find other source= iterations to try.

Can anyone point me in the direction of the the correct source= syntax?

Title: Kismet source= config question
Post by: charlesa on June 18, 2004, 01:00:48 pm

Kill this question ... got it via the README at http://www.kismetwireless.net (http://www.kismetwireless.net)