OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: dansawyer on August 11, 2004, 10:54:48 pm

Title: is this normal for oz-compat install ??
Post by: dansawyer on August 11, 2004, 10:54:48 pm

below is the output from an oz-compat install.  This seemed to work.

Does this require a ipkg-link??

Dan

# ipkg -d sd install /mnt/card/ipks/oz-compat_0.5-4_arm.ipk
Downloading http://www.openzaurus.org/official/experim...sh_0.5-_arm.ipk (http://www.openzaurus.org/official/experimental/collie/3.3.6-pre1-2.4.18-gcc3/ipks//opie-sh_0.5-_arm.ipk)
*** Command: add
*** Locating package
*** Found package on /mnt/card
*** Adding oz-compat
*** Done.

Title: is this normal for oz-compat install ??
Post by: lardman on August 12, 2004, 04:05:34 am

Are you worried that there's no GUI? It shouldn't require ipkg-link, but there's no harm in trying it - 'ipkg-link add oz-compat'.

Don't, you also need to install oz-compat-opie, then you'll get an icon on the settings page which you can use to (as long as you've also installed opie-sh) to run the compat program from the GUI.

Si