OESF Portables Forum
Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: auburn74 on September 12, 2004, 09:04:48 pm
-
Just started using my Zaurus again and would like to use open zaurus 3.3. I have everyhting installed but now I can't sync. I have upgrade to version 3 from Sharp before going to Open zaurus. I have setup a network and windows recognizes the connection. What am I doing wrong. I tried some of the suggestions on the other posts but am still unable to sync
-
Are you getting any error message? If so, what does it read?
Are you using QTopia or IntelliSync under XP? Did you set up "Settings" --> "Security" --> Tab "Sync" --> "select your sync software" correctly on your Z?
Frank
-
I am using intellisync. The zaurus is being can tell the pc is connected but a sync has not occurred. I have upgraded to the Sharp 3.1 rom
-
So, you got it working with Sharp 3.1?
-
I had upgraded to the Sharp 3.10 Rom before I flashed Openzaurus. Still have not been able to sync.