OESF Portables Forum

Everything Else => Zaurus Distro Support and Discussion => Distros, Development, and Model Specific Forums => Archived Forums => Angstrom & OpenZaurus => Topic started by: amitgil on December 03, 2004, 12:10:42 pm

Title: Oz 3.5.2 - Back To The Sharp Image
Post by: amitgil on December 03, 2004, 12:10:42 pm

Hi,

I Loaded OZ 3.5.2 into my SL6000, and have a few questions:

 - With the Sharp image I could enter the diagnostic mode using power+D+M. I can't do that with the OZ image. Anyway I can have that with OZ? How can I reflash back to the Sharp image. I have it backed on the CF.

 - The power button doesn't suspend the device. I think that I saw somewhere a post on that, but couldn't find it. How can I get it to work. Same problem with the rotate button.

Thanks,
Amit.

Title: Oz 3.5.2 - Back To The Sharp Image
Post by: freshroastedpeanut on December 03, 2004, 02:48:06 pm

For diagnostic mode on the 6000, try reset+d+p.

Power button does not work, on 3.5.1 it would set you up into an infinite reboot loop, so it looks like it was disabled in 3.5.2/ Either use the menu or just let it sit for a miute- it will suspend on its' own.

Title: Oz 3.5.2 - Back To The Sharp Image
Post by: amitgil on December 03, 2004, 05:04:15 pm

Tried reset, then Power+D+P, same results. Is that tehe correct sequence? Seems a bit hard to get back to the original image :-(

Thanks,
Amit.

Title: Oz 3.5.2 - Back To The Sharp Image
Post by: amitgil on December 03, 2004, 05:45:06 pm

Ignore the previous post, I got it. Thanks.

Amit.

Title: Oz 3.5.2 - Back To The Sharp Image
Post by: Pyrates on December 04, 2004, 05:34:16 am

Then, how about sharing the solution to your problem?

Cheers
Philipp