Messages

1

SIMpad forum / Gpe/opie Not Starting On Sl4

« on: June 20, 2006, 02:12:57 pm »

Hi,

thanks for your reply, sorry for my bad english. Here are some detailed infos about my simpad-setup:


I followed this guide (http://handhelds.org/moin/moin.cgi/SimPad):

   1. format the CF card using the vfat (or windows FAT) format
   2. copy the rootfs.jffs2 file corresponding to the image you want to install (bootstrap-image-*-simpad.rootfs.jffs2, gpe-image-*-simpad.rootfs.jffs2 or opie-image-*-simpad.rootfs.jffs2) on the CF card, and rename it to rootfs.jffs2
   3. connect the SIMpad to a PC running a terminal emulator (Hyper Terminal on MS Windows, minicom on Linux...) and set the connection to 115200 baud 8 databits no parity 1 stopbit (115200 8N1).
   4. instert the CF card with a PCMCIA adapted in the SIMpad
   5. reset the SIMpad, and immediately press a key (not "Enter") in the terminal. This should give you the "boot>" prompt
   6. Once in a boot prompt, type "copy hda1:/rootfs.jffs2 root"
   7. after flashing is finished, you may want to type "eflash home" if you already did an installation using the hh.org bootloader and you want to erase the home partition
   8. type "boot" in the terminal emulator

--> this works the first time i flashed the image, for reflashing a image i did:

- eflash root
- eflash home
- then point 1 to 6 and 8

-----------------------------------------------------------------
Software Versions:

- gpe-image-v0.8.4-rc2-simpad.rootfs.jffs2
- opie-image-v0.8.4-rc2-simpad.rootfs.jffs2
- blupdater: Serial log says:
>> Compaq OHH BootLoader, Rev 2-21-13 [BIG_KERNEL] [MD5] [MONO]
>> 04-11-20_15:58
>> Last link date: Sat Nov 20 15:58:14 GMT 2004
>> Contact: bootldr@handhelds.org


Greetings,
McClean

2

SIMpad forum / Gpe/opie Not Starting On Sl4

« on: June 19, 2006, 01:46:18 pm »

Hi,

im a newbee in useing the simpad. When i got it (about 2 weeks ago) i first testet and upgraded winCE.
Then i tried the current GPE snapshot (installed using the CF method). All works fine. After playing with GPE i tried the current OPIE image. I used eflash root and eflash home - then i flashed the image like the first time. But it dont works. There are different error messages when doing reset multiple times:

- Kernel bad magic
- Kernel uncompress error
- or just freezing after printing "loading kernel" or "uncompressing kernel"


I tried to flash the old gpe image and some other versions of gpe -> same behavier. What can i do to get the pad working again?


Greetings,
McClean