Messages

1

Angstrom & OpenZaurus / OZ 3.3.6-pre1 on 5600 installs, but Opie wont run.

« on: April 01, 2004, 05:46:06 pm »

I know I had a similar issue the first time I tried installing OZ3.3.6pre1 on my 5600.  
Just after flashing i relaized that I did not have the correct name for the zImage file.  I left the name as zImage.bin.  So it was booting w/ the sharp kernel.

I don\'t remember the correct names currently but they are in the readme.

Once I had fixed the names and reflashed all worked fine.

I flashed it from a SD card  I don\'t currently have a CF memory card.

2

Angstrom & OpenZaurus / 5600 + OpenZaurus 3.3.6 pre1

« on: March 23, 2004, 08:35:35 am »

- Type \'udhcpc -i wlan0\' which should tell you you now have DNS servers.  

one thing I noticed when running this command on 3.3.6 pre OZ on a 5600 was that i received an error in /usr/share/udhcpc/default.script
that said
route command not found
I edited that file and added /sbin/ infront of the route commands and that seems to have fixed the networking issue for me.

3

General Discussion / sl5600 - SD flash keeps going read-only

« on: March 16, 2004, 04:27:25 pm »

I know that I have had the same issue with one 256 Lexar SD while another worked fine.  

I also had the issue occur with the working SD card when I started using the premptive patch on my 5600.  The stock Sharp rom worked.

I found that by changing the mount from the directions at http://www.pocketworkstation.org/

mount /dev/mmcda1 -o remount,sync,noatime

helped the readonly issue with the premtive patch.  It ends up slowing the write down a lot.