Messages

1

Software / How to get Kismet to work on SL-5600 with Sharp Rom

« on: March 18, 2004, 11:58:13 pm »

I found version 2.6.0 on the zaurus software index and that
seems to work!  Should I try to find 2.8.1 (is it better than
2.6.0)?

2

Software / How to get Kismet to work on SL-5600 with Sharp Rom

« on: March 18, 2004, 11:40:22 pm »

When I run kismet_server with no arguments, I get a bus error.
Where is the older version of kismet?  I can try that.

3

Software / How to get Kismet to work on SL-5600 with Sharp Rom

« on: March 18, 2004, 10:50:43 pm »

I suppose I should also mention the versions of the software
I have installed:

kismet:     Feb.04.01
kismet-qt: 2.0.0

Could it be that these are not compatible?

4

Software / How to get Kismet to work on SL-5600 with Sharp Rom

« on: March 18, 2004, 10:30:44 pm »

I am trying to get Kismet to work on a SL-5600 running the
sharp ROM version 1.32.  I installed kismet successfully
and then installed the kismet qt interface.  When the Kismet
app comes up, it goes to the \"Config\" tab.  In that config
tab, I specify:

  Scheme:  Sharp3x-prism2
  Channel:  All US
  Next to SSID: Summary

  (X) Disable Suspend
  (X) Beep on New
  (  ) Disable logging

I then press the \"Restart\" button.  The light on my SMC wireless
card lights up and starts to blink rapidly.  But after a few seconds,
I get the following error message:  \"Can\'t connect to the server\"

I know that I am close.  I think kismet sees the card and it is
gathering information.  But the GUI can\'t see that info because
it can\'t connect.  I have already held down the Kismet icon and
set it to \"Execute with root privilege\".  Is there anything else I
can do to debug the situation?  Are there some command line
commands I can try to see if kismet is working correctly?