Messages

1

Angstrom & OpenZaurus / OZ wireless problems

« on: August 30, 2004, 03:53:58 pm »

Hello everybody,

I have solved my problem. It has been sufficient to insert "s:mypassphrase0" as the key through the graphic configuration tool and not "mypassphrase0" as I did in the past.

Bye,
  MicRos.

2

Angstrom & OpenZaurus / OZ wireless problems

« on: August 27, 2004, 03:29:46 pm »

Hi I have tried the suggested command. After that I am able to run

iwconfig wlan0 -key s:mypassphrase0

and from iwconfig command I can understand to have correctly set my wi-fi card (the key is present and restricted mode is selected). By the way the card does not find the AP (it is shown 44:44:44:44:44) and wi-fi connection does not works.

Some other idea ?

3

Angstrom & OpenZaurus / OZ wireless problems

« on: August 26, 2004, 04:02:04 pm »

After some try I have found the problem: wep encryption. If I set my AP to WEP off and accordingly OZ everything work !!!

Now what I don't know is how to set wep. I mean I need to set up a required shared key authentication and use a 128 bit encryption starting from a string. From the graphical interface it is no possible to set all these thing so I have tried manually to set up /etc/network/interfaces setting s:mypassphrase0 as key and inserting the key word "restricted key" but it does not work.

I have tried to look at OZ site to find a solution without success. Even setting it manually by inserting the command:

"iwconfig wlan0 key s:mypassphrase0"

does not work (receiving the error message SET failed on device wlan0; Operation not supported). How can I do ? Thank you for your answer,
  MicRos.

4

Angstrom & OpenZaurus / OZ wireless problems

« on: August 25, 2004, 03:50:16 am »

* Hi,

this is the output I get using the comand you said:

Socket 0:
  product info: "INTERSIL", "HFA384x/IEEE", "Version 01.02", ""
  manfid: 0x0156, 0x0002
  function: 6 (network)
 
Socket 1:
   no product info available

The strange thing I don't understand is why this card is fully working with original Sharp ROM and is not working at all with OZ (tried 3.2 and 3.3.5). Thank you very much for your support,

  Micros.

5

Angstrom & OpenZaurus / OZ wireless problems

« on: July 25, 2004, 05:58:11 pm »

* Hi,

I am trying to configure OZ to work with CF wireless (recognized as Senao CF by OZ 3.3.5). I successfully used my CF with Sharp Rom: everything worked fine. Now it happens that after having configured it I can see the card trying to capture signal in all the channel even if I  have set it to look only to channel 6. Moreover AP is not found at all (it prints 44:44:44:44:44). The same behaviour using OZ 3.2. I have verified that parameters set in /etc/pcmcia/hostap_cs.conf does match with the ones printed out by the command "cardctl info". I have no more idea, what can I do ? Does anybody has had such a problem. Thanks vey much,

  MicRos.