Messages

1

Zaurus - pdaXrom / Help Request: Bluetooth Bt0100m - D-link Clone

« on: November 23, 2004, 11:37:02 am »

Hi Everyone,

Trying to get my Bluetooth card working on my 860.  The card identifys itself as "Bluetooth BT0100M"  which seems to be a clone of the Dlink DCF650BT, which is listed as having working in the "Bluetooth Card Support" list here on ZUG.

I have used the search, but most of the info I have found is for Sharp-based ROM's not pdaXrom (which I think is great BTW).

What I have done:

On fresh installation, installed all bluez packages from pdaxrom.org feed.

Added card entry into /etc/pcmcia/bluetooth.conf  :

Code: [Select]

card "IOGear CF Bluetooth"
  version  "Bluetooth BT0100M"
  bind "serial_cs" class "bluetooth"
Inserting card with hci_uart module loaded:

Code: [Select]

cardmgr[4330]: socket 0: IOGear CF Bluetooth
ttyS03 at port 0xf60003f8 (irq = 39) is a 16550A
Trying some of the things I found in older threads:

Code: [Select]

#cardctl resume 0
ioctl(): Device or resource busy
# hciattach /dev/ttyS3 bcsp 230400
BCSP initialization timed out
#hcitool dev
Devices:
# hciconfig
hci0:        Type: UART
               BD Adress: 00:00:00:00:00:00 ACL MTU: 0:0  SCO MTU: 0:0
               DOWN
               RX bytes: 0 acl:0 sco:0 events:0 errors:0
               TX bytes: 4 acl:0 sco:0 commands: 1 errors:0
I'm close, just not sure what to try/do next to get this first part of the bluetooth setup done.

PdaXrom doesn't use /etc/bluetooth/uart ?? Correct?

Thanks in advance,
Eric