Messages

1

OpenZaurus/Opie/Qtopia / 5600 Problems With Install

« on: May 19, 2005, 02:18:01 pm »

I've just been told that it is still zImage

I've been using zimage.bin, but I just checked the updater.sh that is in the 3.5.3 feed and it will flash both zimage.bin or zImage.

Note: could this be moved to OZ/Common?(sorry, I couldn't resist that!)  

Greg
[div align=\"right\"][a href=\"index.php?act=findpost&pid=80557\"][{POST_SNAPBACK}][/a][/div]

Thanks.  Just changed the name to zImage.bin and it upgraded the kernel.
Sorry if I posted in the wrong area!

2

OpenZaurus/Opie/Qtopia / 5600 Problems With Install

« on: May 19, 2005, 11:25:13 am »

I am getting the following error on boot of my 5600 after loading oz 3.5.3.  Can anyone assist me with this?

"Warning You are running the wrong kernel"
"You are running '2.4.28-rmk7-pxa3-embedix-021129' I expect kernel ''2.4.28-rmk7-pxa3-embedix-3.5.3'
"running the combination is unsupported"

Here is what I had done.  
I was using the Sharp ROM and wanted to try OZ, so I downloaded these files:

opie-image-poodle-20050409140246.rootfs.jffs2.bin
zImage-poodle-20050409140246.bin
updater.sh

renamed the files to:

initrd.bin
zImage
updater.sh

copied them to my CF card and followed the update instructions.  The update appeared to complete, but I get the error above when I boot.

What did I do wrong?
It eventually does boot into Opie, but I get the same warning when I reset.

Sorry if stupid question.  I am relatively new to Linux/Zaurus.