Show Posts
1
Angstrom & OpenZaurus / Testing Hentges T2 Rc-2 And Stuck At Boot.
« on: June 01, 2005, 05:29:22 pm »
POW!!
Removing the cards after flashing makes sense, sorta but not for the hentges rom BUT it works. Anyway, instead of re-flashing, I rebooted and had the card out when it went into Opie for the first time.
I inserted the card AFTER doing the stylus calibration and it now works.
Looks like the Calibration runs in a much lower res than Opie, so perhaps that accounts for not being able to see the entire dialogue...
Thanks for the tip Jbruno
-Nino
Removing the cards after flashing makes sense, sorta but not for the hentges rom BUT it works. Anyway, instead of re-flashing, I rebooted and had the card out when it went into Opie for the first time.
I inserted the card AFTER doing the stylus calibration and it now works.
Looks like the Calibration runs in a much lower res than Opie, so perhaps that accounts for not being able to see the entire dialogue...
Thanks for the tip Jbruno
-Nino