Messages

1

Angstrom & OpenZaurus / Gnuplot

« on: November 01, 2005, 01:01:14 pm »

No, it's not. I'm using opie 3.5.2, I didn't find gnuplot there. I now saw that there is gnuplot in the 3.5.3 feed, I will install 3.5.3 and use the gnuplot from the OZ feed as soon as I have a little more time.

2

Angstrom & OpenZaurus / Gnuplot

« on: October 31, 2005, 04:37:20 am »

Try 'plot x^2', the syntax for gunplot may be different.

This sounds like a gnuplot syntax issue rather than something specific to the Zaurus.

thanks for your reply, lardman.
'plot x^2' returned 'non-integer passed to boolean operator'.
'^' is the operator for bitwise or, which makes sense to me with the error message above.
I thought it could be a zaurus issue, because I read somewhere, that strongARM processors do not know floating-point instructions (correct me if I'm wrong, I don't really know anything about the ARM-Architecture, or what would happen, if one is compiling c-code that is meant to run on another arch.).
Also, I have now noticed that the problem occurs also with exp() and (therefor?) with sine and cosine.

3

Angstrom & OpenZaurus / Gnuplot

« on: October 28, 2005, 01:15:23 pm »

Hi everyone,
I use gnuplot on my Z5500. If I write 'plot x**2' it plots a line at y=2.
I guess the ** operator does not work properly. I've not tested every operator so far, but I know that 2*x works. Does anyone share this experience?
Thanks in advance.

4

Angstrom & OpenZaurus / Scummvm Load/save/quit Key

« on: June 25, 2005, 02:01:16 pm »

On my zaurus 5500G with opie it's the special key which is marked with a symbol that looks like a pulldown menu (the left one over the ok-button)