Messages

1

C1000/3x00 General discussions / C1000 Symbol/spectrum More Issues :-(

« on: June 24, 2005, 11:53:35 am »

Thanks maslovsky,

I thought that Cacko ROM would be an answer. I'm desperately waiting to move on to Cacko.  Is it likely to be available within the next few months?

Thanks
Mark

2

C1000/3x00 Hardware / C1000 Symbol/spectrum More Issues :-(

« on: June 23, 2005, 06:20:40 am »

Hi all,
I've read a couple of posts regarding the Symbol Spectrum CF card on the C1000. I have successfully connected to my home and work APs without using WEP. However, when I enable WEP, I cannot connect.
I use "iwconfig eth0 key xxxxxxxx".
iwconfig shows the correct WEP key, but alas no luck. Anyone else had this?

Secondly, I'd like to use a wireless sniffer - Kismet, Wellenreiter or such.

I've set my capture source to wlanng,eth0,test and get ETH0: Device or Resource Busy. Setting to wlanng,wlan0,test gets: Interface wlan0: no such device.
I've tried setting up a dummy wireless connection as suggested elsewhere, but still no joy.

Wellwenreiter gives me SIOCSIFFLAGS: Device or resource busy. using eth0

I've tried entering my cardctl ident info into wlan-ng.conf.

Tearing my hair our now mad.gif

Does anyone else have this combination working with WEP and with a sniffer?

Thanks in advance!
Bar0n

3

C1000/3x00 General discussions / C1000 Symbol/spectrum More Issues :-(

« on: June 22, 2005, 05:47:14 am »

Hi all,
I've read a couple of posts regarding the Symbol Spectrum CF card on the C1000. I have successfully connected to my home and work APs without using WEP. However, when I enable WEP, I cannot connect.
I use "iwconfig eth0 key xxxxxxxx".
iwconfig shows the correct WEP key, but alas no luck. Anyone else had this?

Secondly, I'd like to use a wireless sniffer - Kismet, Wellenreiter or such.

I've set my capture source to wlanng,eth0,test and get ETH0: Device or Resource Busy. Setting to wlanng,wlan0,test gets: Interface wlan0: no such device.
I've tried setting up a dummy wireless connection as suggested elsewhere, but still no joy.

Wellwenreiter gives me SIOCSIFFLAGS: Device or resource busy. using eth0

I've tried entering my cardctl ident info into wlan-ng.conf.

Tearing my hair our now  

Does anyone else have this combination working with WEP and with a sniffer?

Thanks in advance!
Bar0n