Messages

1

5x00 General discussions / Kismet Problems On 5600

« on: October 01, 2005, 02:06:05 pm »

You're probably missing a lib which kismet-server requires.

Try running kismet-server from the command line and see what the error is.


Si

P.S.

Missed this bit:

I'm Clueless when it comes to working with the terminal, so if you have terminal instructions pretend you are teaching a 3 year old how to do it.

Do you have a terminal installed? If not, I'm not sure where the download link is I'm afraid, but it should be in the ZUG downloads (linked from www.oesf.org).

Then just type kismet-server on the command line and see what happens.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=97769\"][{POST_SNAPBACK}][/a][/div]

Thanks lardman,  Yes I have terminal installed but I have'nt lerarned how to use it properly yet.
I will reinstall the ipk and qt front end and try typing in the kismet-server and see what happens.
Here is my e-mail if anyone has any suggestions.   wchilders@swfla.rr.com
Thanks again.

2

5x00 General discussions / Kismet Problems On 5600

« on: September 30, 2005, 08:48:14 pm »

Trying to get Kismet working  on my SL5600. I have tried different ipks along with kismet-qt front end.  I keep getting the the error-Can not connect to server
I'm using a Ambicom WL1100C, dont know if its compatable with Kismet.
If anyone hase a working ipk that I could download or instructions on how to get it working I would appreciate it.
I'm Clueless when it comes to working with the terminal, so if you have terminal instructions pretend you are teaching a 3 year old how to do it.
Thanks