Messages

1

C1000/3x00 General discussions / Cacko Rom 1.23 For C1000 Progress

« on: November 08, 2005, 09:23:56 am »

Not sure what happened, but after going through the whole flash process, after the final reboot, I'm getting an error "sh: can't access tty:  job control turned off" and then an '#' prompt.

I've been through the flash process a few time - all with the same results.  Any thoughts on what went wrong?  This is on a c1k.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=102512\"][{POST_SNAPBACK}][/a][/div]

Try to increase the root partition size to 34 or even 34 Mb and flash again.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=102643\"][{POST_SNAPBACK}][/a][/div]

Thanks Anton!  Turned out that I needed to reformat the CF disk and re-extract the files to it.  After that, everything worked great.  

And thanks for putting this together!  This is soooooo much better than the stock ROM!  I was able to get my network connection to work for the first time last night since buying this!  Simply glorious.

2

C1000/3x00 General discussions / Cacko Rom 1.23 For C1000 Progress

« on: November 06, 2005, 01:35:28 am »

Not sure what happened, but after going through the whole flash process, after the final reboot, I'm getting an error "sh: can't access tty:  job control turned off" and then an '#' prompt.

I've been through the flash process a few time - all with the same results.  Any thoughts on what went wrong?  This is on a c1k.