Messages

1

SIMpad forum / No Serial Download Request

« on: March 25, 2006, 07:55:03 am »

Well...
I found the solution on the opensimpad.org forum:
I´m using Windows. I disabled the FIFO of the COM port in the device manager.

That did the trick. Unfortunately, the image that´s loaded is not very stable so I guess I´ll have to find somehting better...

Ronald

2

SIMpad forum / No Serial Download Request

« on: March 06, 2006, 10:02:29 am »

ronaldw,

type the serload command and then hit ENTER and reset the Simpad at the same time, not ENTER first and then reset. Sometimes helps.

Digi
[div align=\"right\"][a href=\"index.php?act=findpost&pid=116986\"][{POST_SNAPBACK}][/a][/div]

Thanks, I will try it. I'm afraid I bricked my simpad, but I guess there's still hope...

Ronald

3

SIMpad forum / No Serial Download Request

« on: March 04, 2006, 10:36:46 am »

Dear all,
I´ve been trying to upgrade my Simpdad SL4 but now it got stuck... I first wanted to try to upgrade to a newer windows verson, although in the end I would prefer using linux

What I´ve done so far:

loaded loader_bl using serload. That went, as far as I could tell, as it should.

then I tried loading wince image on the simpad using serload. Ever since it gets stuk.
When I boot, it doesn´t get past the multicolored checkered screen. Using hyperterminal, I get the following message:

Code: [Select]

PBL V2.4 20.07.2001
Booting...
================================================
Siemens Switzerland Bootloader V2.5.3 10.06.2003
Running @206Mhz Processor ID 0x6901b118
Press ESC for monitor
Occupied Memory: [0x00004000-0x00008000],[0x01f00014-0x01f6d00c]
Flash Id 0x00000018 at virt adr 0x05000000 Size 0x01000000
No 32Bit Flash detected 0x00000000
FlashImage Checksum 0x05040014-0x05059f11=0xa6a4ca93 Bootloader Image OK
Fabdata Flash @0x05059f18 Ram @0x01f19f18 FABDATA: S842-CZTZC
MQ200 - Revision ID=2 ...
Initialise PCMCIA Interface... done.
Codec UCB1200 ID:0x1005 Ver.5 Dev.0 Suppl.1 IO 0x00000000
No PCMCIA Card Attached
NO PCMCIA CARD!  -- Use serial IO
Sysinit done
No serial download request
Boothdr at 0x05080000 -> 0xffffffff
Calling Monitor

=====================
Monitor:
=====================
Boot from Flash   'f'
Boot from Net     'n'
Power Off         'o'
Erase PSM+Registry'p'
Exit              'q'
Erase Registry    'r'
Erase Flash       'y'
Soft  Reset       's'
Print Fab-String  'w'
->
Now, whatever I try from there, nothing works. all option do work, btw, except for exit. But for example 'w' results in the fab-string being printed.

Is there a way to get back to some working version of my simpad or progress straight away to a linux version?

Any help would be greatly appreciated.

Regards, Ronald