Messages

1

Angstrom & OpenZaurus / Openzaurus 3.5.4.1 Testing

« on: March 27, 2006, 11:42:23 am »

The default settings for audio-output on my Zaurus C3100 seems a bit strange. To enable support for headphones I need to play around with alsamixer. Otherwise all audio is played through the built-in speaker, even if I have plugged in headphones.
Perhaps it would be a good idea to enable headphone sensing by default?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=120462\"][{POST_SNAPBACK}][/a][/div]

Which settings did you change to which value exactly?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=120472\"][{POST_SNAPBACK}][/a][/div]

Using alsamixer, I had to change "Jack Function" to Headphone and "Speaker Function" to Off, otherwise audio would play from both the speaker, and the headphones. However, I can't seem to reproduce the error when I try to revert back to the old settings, so I'm guessing maybe it was something temporary.
Has anyone else encountered similar problems?

2

Angstrom & OpenZaurus / Openzaurus 3.5.4.1 Testing

« on: March 27, 2006, 09:44:08 am »

The default settings for audio-output on my Zaurus C3100 seems a bit strange. To enable support for headphones I need to play around with alsamixer. Otherwise all audio is played through the built-in speaker, even if I have plugged in headphones.
Perhaps it would be a good idea to enable headphone sensing by default?

3

Angstrom & OpenZaurus / Openzaurus 3.5.4.1 Testing

« on: March 22, 2006, 02:50:29 pm »

In the installation instructions for C3100 it is stated that OZ will be installed to the hard-drive instead of to flash. Is this still the case? Isn't there any way to install to flash instead, seems like a bit of a waste not to use the built-in 128 MB flash rom...