Messages

1

Sharp ROMs / Upgrading C3000/cacko To Tetsu Kernel

« on: April 03, 2006, 08:51:19 am »

w100 is needed on on c7x0 machines

cxx00 machines use bvdd under 2.4
[div align=\"right\"][a href=\"index.php?act=findpost&pid=121589\"][{POST_SNAPBACK}][/a][/div]

w100 have better performance in mplayer?

2

Sharp ROMs / Upgrading C3000/cacko To Tetsu Kernel

« on: April 03, 2006, 07:08:51 am »

you only need to upgrade the tetsu special kernel if you are running stock Sharp ROM or are using the Cacko beta for C3000. Cacko 1.23 does not require tetsu kernel update because its already included.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=121565\"][{POST_SNAPBACK}][/a][/div]

it's because cacko 1.23 kernel have no "w100" driver

3

Sharp ROMs / Upgrading C3000/cacko To Tetsu Kernel

« on: April 02, 2006, 10:05:01 pm »

I followed the instructions just as danboid mentioned above, except I downloaded the C3100 files for my C3100.
zImage-v18b-C3100.bin
updater.sh.c3100
I renamed these files and the install seemed to go fine until I reset my zaurus with the stylus in the battery compartment hole.
It rebooted and it is now stuck on a long list of errors:
There are only 2 errors showing now. The first error is repeated 7 times. It is:

ERROR: /usr/sharp/etc/launch.conf -- can not open file
ERROR: launch.conf -- can not open file

The second error is at the bottom and it is:
INIT: id "ln" respawning too fast: disabled for 5 minutes

I have waited at least 15 minutes and nothing has happened. The curser is blinking below this second error, but nothing is happening. I can't type into the screen either.

Is it bricked at this point?
Should I use my restore, and restore my Z

Thank you for any suggestions,
Jon
EDIT: I'm now able to type into the screen now. Any suggestions what I could try??
[div align=\"right\"][a href=\"index.php?act=findpost&pid=114038\"][{POST_SNAPBACK}][/a][/div]

Same pb for me.....
[div align=\"right\"][a href=\"index.php?act=findpost&pid=120327\"][{POST_SNAPBACK}][/a][/div]

Same pb for me three! I think this kernel can not use with Cacko.