1
General Discussion / How To Setup Irda-ppp? (sonyericsson K608i+c3200 Cacko 1.23)
« on: October 09, 2009, 02:02:22 am »
Hi folks,
I am still trying to set up an IrdA-PPP connection between my Sony Ericsson k608i (somewhat dated.....just like the Zaurus:)) and my newly acquired SL C-3200.
I had the same Sony Ericsson k608i connected to my old Psion 5mxPro which always worked.
But I have never used IrdA-PPP on the Zaurus, so if somebody can give me a comprehensive general introduction, that would be appreciated as well!
So far I have tried following init-strings:
at e0<cr>at+cgatt=0<cr>at+cgdcont=3,"ip","drei.at" or AT+CGDCONT=1,"IP","drei.at","0.0.0.0",0,0
and
AT+CGDCONT=1,"IP","drei.at","0.0.0.0",0,0
My provider is in Austria called "Drei", and the APN is on first place on my phone.
On my Psion I only had to type in the calling number which was: *99***1#, do I need to put this at the "phone" line in the network connection??
Are there any other suggestions?
Thanks: Balazs
I am still trying to set up an IrdA-PPP connection between my Sony Ericsson k608i (somewhat dated.....just like the Zaurus:)) and my newly acquired SL C-3200.
I had the same Sony Ericsson k608i connected to my old Psion 5mxPro which always worked.
But I have never used IrdA-PPP on the Zaurus, so if somebody can give me a comprehensive general introduction, that would be appreciated as well!
So far I have tried following init-strings:
at e0<cr>at+cgatt=0<cr>at+cgdcont=3,"ip","drei.at" or AT+CGDCONT=1,"IP","drei.at","0.0.0.0",0,0
and
AT+CGDCONT=1,"IP","drei.at","0.0.0.0",0,0
My provider is in Austria called "Drei", and the APN is on first place on my phone.
On my Psion I only had to type in the calling number which was: *99***1#, do I need to put this at the "phone" line in the network connection??
Are there any other suggestions?
Thanks: Balazs