1
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I saw this photo and recognized a sd/mmc slot inside ... which sort auf adapter / socket do you use? I saw a little board at the mmc/sd slot.
is it possible to switch the bt module on / off per software (using an unused bit of the port)? What about using a hardware switch?
QuoteI see opie loading via the serial link, the screen blinks ,then, dimmly and nothing goes on.
can I test that the screen is connected right? any way to "ping" the screen?
i had similar problem- did you correctly connect tape to screen:
it's uper tape and it must be inserted UNDER black plastic
(lower tape is insterting UNDERblack tape - so it can be confusing)
[div align=\"right\"][a href=\"index.php?act=findpost&pid=148852\"][{POST_SNAPBACK}][/a][/div]
Sorry to be a party pooper, but...
I've had three bad experiences with geeks.com.
1. Refurbished laptop - junk (I should have known better).
2. Refurbished 2.5" mobile hard drive - junk (I really should have known better).
3. New 4GB USB hard drive - junk.
I would never buy anything from them again.
I hope you have better luck with your purchase.
Regards,
Doug
[div align=\"right\"][a href=\"index.php?act=findpost&pid=146145\"][{POST_SNAPBACK}][/a][/div]
root@simpad:~# /etc/init.d/opie stop
Stopping Opie...
root@simpad:~# ". /etc/init.d/opie"
-sh: . /etc/init.d/opie: not found
root@simpad:~# . /etc/init.d/opie
usage: -sh { start | stop | restart }
root@simpad:~# qpe -nodaemon
ODevice() - found 'Hardware : Simpad'
OGlobal::creating global configuration instance.
OConfig::OConfig()
<unknown>: ODevice reports transformation to be 0
<unknown>: setting QWS_DISPLAY to 'Transformed:Rot0:0'
QWSApplication::qt_init() - current terminal specified.
QWSKeyboardHandler: using SIMpad switches handler...
SimpadButtonsHandler() - V4.1
mcp: write timed out
: FATAL: Error 2 opening face
Segmentation fault.