Hi Folks,
just got my Z (SL-5500G) a couple of day ago and as it had an earlier version of the Cacko ROM installed, I flashed the lates version [Cacko/Crow ROM update 3.10 (Kernel 2.4.18)]
Now I have some questions and need help.
'dmesg' shows lots of '-W- Don't delete.' Where does that come from and how can it be fixed?
How can I enable logging into /var/log/messages? (temporary and permanently)
I think I read something like 'echo xx > /proc/...' but can't find it anymore.
If I use my 'Socket low Power Ethernet' CF-Card (10Mbit) on a ASUS WL-HDD it works fine (with static as well as dynamic ip-addresses), but if I try to use it on a 10 MBit Hub or with a crossover cable on a laptop I get 'Connection Error - No Connetion detected. - Check your TCP/IP settings.'
The funny thing is that, as long as I don't acknowledge the message, everything (ping, ssh, smb, etc) works. If I'm connected to the Z (e.g. ssh) via eth0 when I acknowledge the message I get a 'Network device bussy' message but the interface then stays up.
'ifconfig -a' via ssh shows me the following.
eth0 Link encap:Ethernet HWaddr 00:C0:1B:06:47:EB
inet addr:192.168.75.99 Bcast:192.168.75.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:101 errors:0 dropped:0 overruns:0 frame:0
TX packets:60 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:12485 (12.1 Kb) TX bytes:5718 (5.5 Kb)
Interrupt:35 Base address:0x300
How can I fix this behavior?
Furthermore, where can I get more details/information about the /dev/mmcdax and /dev/mtdblockx devices?
Cheers,
pepe
