Perhaps someone has the last bit of info I need to get Wellenreiter working on my Z 5600. I've followed numerous instructions on how to get Wellenreiter working on the Zaurus. The instructions worked fine on the Zaurus 6000L I own. However, on my Z 5600 -- when I go to configure wellenreiter (which is required before doing a scan), I cannot get anything but a blank popup window when I go to select the network device -- I'm expecting either wlan0 or eth0 (on the 6000L wlan0). The network I am starting is configured as:
IP: 1.1.1.1
Gateway: 1.1.1.0
Subnet mask: 255.255.255.0
Network is ad-hoc.
Wellenreiter has root permissions.
ROM is Sharp 1.32, and I am running Qtopia 1.5.4
The wireless card is known to work well for getting on the net with this Zaurus 5600. One clue I think is that the wireless card activity light is solid green when I start -- I am expecting it to be blinking like it does on my 6000L. I also noticed that instead of wlan0, the active network device is eth0. But this is true also when I am using the network card configured by my wireless router via DHCP -- apparently some changes happened in the Qtopia ROM between the 5600 and the 6000L.
So, do I need an upgrade of the Sharp ROM to make this work? Or is there some magic I need to apply to get what works as advertised on the 6000L working on my 5600? Or is an alternate ROM/environment necessary (I did get wellenreiter working on an older Zaurus 5500 which I had flashed with OpenZaurus/Opie, but I want to stick with the Sharp ROM and Qtopia at this point in time).
Regards, and thanks in advance.
