Author Topic: Pdaxrom 1.1.0beta3 And Nmap  (Read 1868 times)

BerndS

  • Jr. Member
  • **
  • Posts: 65
    • View Profile
Pdaxrom 1.1.0beta3 And Nmap
« on: March 27, 2007, 04:55:27 pm »
Hi again,

I can't get nmap to work in pdaXrom1.1.0beta3:

root@/mnt/ide3/new> nmap -O -sS 192.168.178.195

Starting Nmap 4.20 ( http://insecure.org ) at 2005-03-27 10:08 CEST
dnet: Failed to open device eth0
QUITTING!
root@/mnt/ide3/new>

root@/mnt/ide3/new> nmap -e /dev/eth0 -O -sS 192.168.178.195

Starting Nmap 4.20 ( http://insecure.org ) at 2005-03-27 09:53 CEST
I cannot figure out what source address to use for device /dev/eth0, does it even exist?
QUITTING!


root@/mnt/ide3/new> ifconfig -a
eth0      Link encap:Ethernet  HWaddr 00:E0:98:B0:58:1C
          inet addr:192.168.178.9  Bcast:192.168.178.255  Mask:255.255.255.0
          UP BROADCAST NOTRAILERS RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:35536 errors:0 dropped:22 overruns:0 frame:14
          TX packets:38401 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:5918427 (5.6 Mb)  TX bytes:36598693 (34.9 Mb)
          Interrupt:135 Base address:0x300

irda0     Link encap:IrLAP  HWaddr 62:4d:00:00
          UP RUNNING NOARP  MTU:2048  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:6246 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:8
          RX bytes:0 (0.0 b)  TX bytes:195409 (190.8 Kb)

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:33847 errors:0 dropped:0 overruns:0 frame:0
          TX packets:33847 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:44900528 (42.8 Mb)  TX bytes:44900528 (42.8 Mb)


root@/mnt/ide3/new> ipkg status nmap
Package: nmap

Status: install ok installed
Root: /mnt/ide2
Version: 4.20

pcre is also installed:

root@/mnt/ide3/new> ipkg status pcre
Package: pcre
Status: install ok installed
Root: /
Version: 5.0



root@/mnt/ide3/new> uname -a
Linux zaurus 2.4.20 #1 Sat, 25 Mar 2006 15:03:52 +0000 armv5tel unknown
root@/mnt/ide3/new> nmap -e /dev/eth0 -O -sS 192.168.178.195

root@/mnt/ide3/new> which nmap
/usr/bin/nmap

root@/mnt/ide3/new> ldd /usr/bin/nmap
        libssl.so.0.9.7 => /usr/lib/libssl.so.0.9.7 (0x40028000)
        libcrypto.so.0.9.7 => /usr/lib/libcrypto.so.0.9.7 (0x4005d000)
        libstdc++.so.6 => /usr/lib/libstdc++.so.6 (0x40165000)
        libm.so.6 => /lib/libm.so.6 (0x40244000)
        libgcc_s.so.1 => /lib/libgcc_s.so.1 (0x402f3000)
        libc.so.6 => /lib/libc.so.6 (0x40304000)
        libdl.so.2 => /lib/libdl.so.2 (0x40424000)
        /lib/ld-linux.so.2 => /lib/ld-linux.so.2 (0x40000000)


Running on the SharpROM nmap runs without problems.

The network card is 10/100 Apollo ethernet card :

eth0: NE2000 (DL10022 rev 05): io 0xf6000300, irq 135, hw_addr 00:E0:98:B0:58:1C
eth0: found link beat
eth0: autonegotiation complete: 100baseT-FD selected


Bernd