← previous next →
Pages: [1]

Author Topic: kismet  (Read 2919 times)

Dr.HerbertWest

  • Newbie
  • *
  • Posts: 28
    • View Profile
kismet
« on: August 09, 2004, 07:02:11 pm »
I am using 1.0.5 pdaxrom with kismet. I have a spectrum24 wireless card my only question is on the source line should i have it it using spectrum_cs?


source=spectrum_cs,eth0,orincosouce
Logged

Dr.HerbertWest

  • Newbie
  • *
  • Posts: 28
    • View Profile
kismet
« Reply #1 on: August 09, 2004, 07:08:11 pm »
that did not work so I changed it to

source=orinco,eth0,spectrum_cs


my card seems to be stuck in busy any one know why? i get a warning now when i try to use kismet

says my card is not fully working that i should restart or reconfigure it

then kismet exits
Logged

obs1

  • Newbie
  • *
  • Posts: 26
    • View Profile
kismet
« Reply #2 on: August 10, 2004, 04:33:55 pm »
hi doc -

i also have the same issue - installing an older version solved my problem. Does anyone else have any idea why the latest version doesn't work well with the symbol cf ?

good luck!
Logged

Dr.HerbertWest

  • Newbie
  • *
  • Posts: 28
    • View Profile
kismet
« Reply #3 on: August 11, 2004, 05:04:29 am »
what version are you using and here did you find it?
Logged

obs1

  • Newbie
  • *
  • Posts: 26
    • View Profile
kismet
« Reply #4 on: August 16, 2004, 02:18:57 pm »
version: Feb.04.01
Logged

tz

  • Full Member
  • ***
  • Posts: 102
    • View Profile
    • http://
kismet
« Reply #5 on: August 17, 2004, 03:58:04 pm »
Kismet requires a patched version of the spectrum and orinoco drivers (to enable monitor mode).  Also earlier versions of kismet 3.x didn't have a needed delay so  would confuse the card.

I think it was iwconfig or iwpriv to turn on monitor - if it doesn't work you need to update the driver.
Logged
Pages: [1]
← previous next →