Author Topic: 5600, 3Com & Netgear??? (Read 3901 times)

Anonymous · « **on:** January 19, 2004, 09:45:13 pm »

Has anyone experienced any problems with DHCP on 3Com routers?

z5600 running 2.4.18-rmk7-pxa3-embedix
rom 1.21

through Netgear MA701

through 3Com access point

to 3Com dsl router issuing DHCP.

If I set the address on the 5600 to static I get connectivity for about 2 seconds and then it bombs out with a \'no connection detected, check your TCP/ip setting\' yet the connection mananger shows a link and the LED is on until I click OK on the warning and then the link is shut down.

IF I set the 5600 to DHCP it just times out.

ring any bells with anyone?

awoehler · « **Reply #1 on:** February 20, 2004, 04:52:58 pm »

I have a simpiliar problem any solutions would be appreciated.

dz · « **Reply #2 on:** February 20, 2004, 07:26:24 pm »

this seems to be a common problem among 5600\'s.. i dont know of any fix yet

awoehler · « **Reply #3 on:** February 23, 2004, 09:20:11 am »

I noticed that the ma701 is not in the wlan.conf file.
cardctl gives me the following messages

cardctl ident
Socket 0:
product info: \"NETGEAR\", \"MA\", \"\"
Socket 1:
no product info available

cardctl status
Socket 0:
3.3v 16-bit PC Card
function 0: [ready]

RadioRental · « **Reply #4 on:** February 23, 2004, 09:22:43 am »

fyi, I posted the original problem and traced the problem to a faulty cat5 cable. I now have no problem with the described setup

News:

Author Topic: 5600, 3Com & Netgear??? (Read 3901 times)

Anonymous