Incomplete Flash?

[shinRaiden]

System is a CL-860.

Flashing seemed to go ok, no complaints iirc.

Now when I go for a first-boot, I get the logo in the corner, then it flashes to the second screen.

INIT: Entering Runlevel: 2
Starting portmap daemon: portmap/sbin/portmap already running.
364
.
Starting advanced power management daemon: start-stop-daemon: stat /usr/sbin/apm
d: No such file or directory
(failed.)
Starting irattach: .
Starting PCMCIA services: cardmgr[519]: watching 2 sockets
done.
Starting syslog/klogd: done
Starting Bluetooth subsystem: hcid sdpdCan't open HIDP control socket: Non such f
ile or directory
 hidd rfccom.
Starting GPE display manager: gpe-dm

and that's where it leaves off.

The email light is blinking once every 3~4 seconds too.

The power button on the back properly suspends it seems, and I have a blinking box on the line following the "gpe-dm" line.

Just tried another flash, same results. Email light is not flashing yet though.

Any ideas?

[mimeca]

Have you check MD5 sum? Some times, rom image isn' complete and give you some problems. If you checked, have you format your CF before? (this is not a necesary step, but sometimes it give me problems with flashing).

[shinRaiden]

no, haven't checked out everything there yet, I'm wondering if maybe I have 'wrong' partition sizes. At least I'm not in a panic though, since I'm paranoid enough to make a full NAND flash backup before I try to zap a new system on it, so I'm back up and running, but not with OE-GPE yet.