Remote Control

[Mjolinor]

I just sold my 860 and forgot that I had a CE-RH1 remote so I now need to alter it to make it work on my 3000 ie change it into a CE-RH2.

Assuming it works in the same way the I just need the impedance values for the 5 functions.

The RH1 control is from the two connections on the plug nearest to the wire, not the tip.

The RH1 is a follows.

No button: OC
Volume up: 2500 ohms
Volume down: 6400 ohms
Fast forward: 1300 ohms
Fast rewind: 700 ohms
Stop: 360 ohms

Will some kind person please measure those on an RH2.

[Da_Blitz]

resistance values for RH2. 330, 470, 680, 910,1.5k,3.3k,18k

see https://www.oesf.org/forums/index.php?showt...15333&hl=ce-rh2 for schematic, just change the vals to the ones noted above (notice the asscending order on both

[dbowden]

resistance values for RH2. 330, 470, 680, 910,1.5k,3.3k,18k

see https://www.oesf.org/forums/index.php?showt...15333&hl=ce-rh2 for schematic, just change the vals to the ones noted above (notice the asscending order on both
[div align=\"right\"][{POST_SNAPBACK}][/a][/div]

Don't forget to swap the Key and GND wires to the connector.  They got swapped between the CE-RH1 and CE-RH2.  See [a href=\"https://www.oesf.org/forums/index.php?showtopic=15333&hl=creative%20zen&st=15#]this discussion.[/url]

[Mjolinor]

OK thanks for the input. I did try searching.

[Da_Blitz]

searching for more than one word dosent work like it does on google so watch out, it seems to look for the entire phrase

[Mjolinor]

searching for more than one word dosent work like it does on google so watch out, it seems to look for the entire phrase
[div align=\"right\"][a href=\"index.php?act=findpost&pid=118481\"][{POST_SNAPBACK}][/a][/div]

You can use boolean operators

 searching for "searching AND word" will bring back your post.