Getting Network To Work On 3.5.4.1

[liberated]

I can't get the network to work. The ethernet card (not wireless) is running OK, eth0 is up, ip address is assigned and all, but I can't reach anything. I can ping addresses but http and ftp seems blocked, ipkg and minibrowser just times out.

This is a completely fresh install. Any ideas? The problem is definitely in the Zaurus because network is OK from other machines.

[lardman]

What are the IP addresses you have set on either side of the connection?

Do you have routing setup correctly?


Si

[donnatn]

I had to set up the wireless connection on eth0 and for DHCP.  Then it worked fine.

I had read to use wlan0 but that didn't work.

I want to know how to set up the Z to use something like wififofum (http://www.aspecto-software.com/rw/applications/wififofum/)

I want to be able to find something that will pick up on networks and let me connect to them.  I am running OZ GPE.

Does anyone know of anything?

[jerrybme]

I had to set up the wireless connection on eth0 and for DHCP.  Then it worked fine.

I had read to use wlan0 but that didn't work.

I want to know how to set up the Z to use something like wififofum (http://www.aspecto-software.com/rw/applications/wififofum/)

I want to be able to find something that will pick up on networks and let me connect to them.  I am running OZ GPE.

Does anyone know of anything?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=135228\"][{POST_SNAPBACK}][/a][/div]

Try prismstumbler (make sure to install the frontend too) Also wifi-radar is good just for connecting (you won't get any ware-driving info) For wifi-radar, you'll need to enable either the Perl or Python feeds- I don't remember which.

Cheers,
Jerry