New Releases Bugs/issues And Fixes (plz Post!)

[willgan]

Issue on Akita:

There seems no bvdd support:

# modprobe bvdd
FATAL: Module bvdd not found
[div align=\"right\"][a href=\"index.php?act=findpost&pid=159369\"][{POST_SNAPBACK}][/a][/div]

If not mistaken bvdd is only for kernel 2.4 , kernel 2.6 uses pxafb...

[kkazakov13]

any news on the clock reset to 1970-01-01 after reboot?

[Civil]

any news on the clock reset to 1970-01-01 after reboot?

If you use reboot - it syncs sys clock to hardware. And it'll remain normal till you pull out your battery (then it'll be 1970-01-01-00:00 )

[scheck.r]

---------------------brightness------------------
above 30% screen is bright
below 30% screen is dimmed
below 25% battery icon is red
below 13% Z shuts off
Problem: if apm indicates around 30% screen is blinking for like 15mins cause battery status
goes up and down around 30%.
I would be better to setup a range of values like dimmed between 10% and 20% instead of just one value
Is it possible to change these values without recompiling ?
I think matchbox-battery-applet was able to do that in beta3
[div align=\"right\"][{POST_SNAPBACK}][/a][/div]

May be this is related to this thread [a href=\"https://www.oesf.org/forums/index.php?showtopic=24103&pid=162427&st=0&#entry162427]https://www.oesf.org/forums/index.php?showt...=0&#entry162427[/url]

However, if you want the speed to be adjusted automatically then you'll have to utilize the following apm option:

  -A      Set apmd( to automatic performance adjustment mode.  In this
            mode, when CPU idle time falls below 10%, or if the AC power is
            connected and the battery is more than 15% charged, apm raises
            hw.setperf as much as possible.  Otherwise, when the CPU idle
            time is above 30% and the system is running on battery power, apm
            lowers hw.setperf as much as possible to reduce power consump-
            tion.