Messages

1

Windows Issues / SL5500, V3.1, Intellisync, TCP/IP, USB problems

« on: November 09, 2004, 08:48:06 am »

I sure did.  I read the pgrade instructions carefully and folloed them as closely as possible (I remember them not being very exact).

At any rate, I don't believe this to be the poblem.

2

Windows Issues / SL5500, V3.1, Intellisync, TCP/IP, USB problems

« on: October 22, 2004, 04:39:03 pm »

Hello, everyone!
       I'm having problems syncing my SL5500 with Intellisync via TCP/IP.  This used to work fine with ROM 2.38, but ever since I upgraded to V3.1 (It's been a while) I can't sync via TCP/IP.  If I switch to USB/IO, then things are fine, but then I lose all of my network connectivity to my zaurus.
       When I switch to TCP/IP, I can ping, telnet, and FTP to my zaurus with no problems, so I know basic networking is functioning.  When I press the SYNC button on the cradle, nothing happens on my PC.  If I run the Synchronize application on my PC, my Zaurus goes in and out of Sync mode and then the sync finally fails.
       Again, if I switch to USB/IO synchronization works just fine.

       Any ideas?  Thanks!

-=Matt=-