Show Posts
1
6000 - Tosa / Zaurus 6000l & Wifi Usrobotics
« on: December 25, 2004, 02:58:55 am »
dixie,
You didn't include the config of the Access Point you are trying to connect to, I assume that you have verified the Z settings against the AP settings. Why did you try the different ESSID's? What is the AP ESSID? Also 192.168.1.22 seems odd as a default gateway address, not invalid, just usually see 1.1 or 1.254, etc.
Some more questions, have you tried setting the ESSID to Non-Specific or "ANY" ? Is there any encryption running on the AP, WEP, WPA etc? Are there any restrictions on which MAC addresses can connect set on the AP? Is the AP set to accept a specific speed connection, i.e., greater than 11Mbps, or 802.11g? Can you set the Z to dhcp and try pulling an address from the AP? Can you connect to the AP from another system, if so what are it's settings? Is there any firewalling associated with the AP? You say you checked the iwconfig wlan0 settings, I assume you mean ifconfig, what are the DNS Settings there, none are included in your post, are they valid?
Just a few basic questions, I hope they help you find the answer to your problem. I doubt that the issue is related to and incompatability between the chips. Good luck!
You didn't include the config of the Access Point you are trying to connect to, I assume that you have verified the Z settings against the AP settings. Why did you try the different ESSID's? What is the AP ESSID? Also 192.168.1.22 seems odd as a default gateway address, not invalid, just usually see 1.1 or 1.254, etc.
Some more questions, have you tried setting the ESSID to Non-Specific or "ANY" ? Is there any encryption running on the AP, WEP, WPA etc? Are there any restrictions on which MAC addresses can connect set on the AP? Is the AP set to accept a specific speed connection, i.e., greater than 11Mbps, or 802.11g? Can you set the Z to dhcp and try pulling an address from the AP? Can you connect to the AP from another system, if so what are it's settings? Is there any firewalling associated with the AP? You say you checked the iwconfig wlan0 settings, I assume you mean ifconfig, what are the DNS Settings there, none are included in your post, are they valid?
Just a few basic questions, I hope they help you find the answer to your problem. I doubt that the issue is related to and incompatability between the chips. Good luck!