Messages

1

Cosmo Communicator - Android / Manual Firmware Installation Files from Planet

« on: June 29, 2020, 04:54:15 pm »

Nah, seems my APN setup was wrong  

Let's hope for resolution of the intermittent locking issue then…  

2

Cosmo Communicator - Android / Manual Firmware Installation Files from Planet

« on: June 29, 2020, 04:25:53 pm »

I've had intermittent https issues on 4G with v20 and v22, ref.:
 [ Invalid Attachment ]

I also had intermittent locking of the screen during active use.

So i have just carried out a manual installation of v22, over the v22 from over-the-air, and hopefully that resolves those two issues.

(I took a backup beforehand, but lost no user data on the device from the upgrade.)

3

Site Suggestions, Requests, and Updates / problem accessing forum (via IPv6?)

« on: March 29, 2020, 02:31:03 pm »

I seem to have problems accessing this forum via IPv6. When I try to open any forum, I only one line in firefox: "Could not determine your IP address".

I have the same issue.

4

Cosmo Communicator - Android / Mobile data

« on: March 05, 2020, 03:10:39 pm »

Ok worked it out.  UI is very bad, and default settings (that you can't seem to access right now) have the second/eSIM as the data sim!

Turning mobile data off, then on again, and say "Yes please change the SIM used" fixed it.

Thanks! I had a similar problem.

As you, I was not able to activate the 4G connection, but the issue was that "Preferred SIM for Mobile data" was not set. Setting it to my only SIM in slot 1 and activating mobile data was enough to get it going