Can You Use Pcmcia Cards

[ElvisII]

Hi,

I want to attach a PCMCIA card to my zaurus, not a CF card but a full blown PCMCIA. I have seen references to PCMCIA expansion ports but can't find any specific products.

This is so I can attach the Zaurus to a 3G data card for on the move connectivity, GPRS is nice but 3G would make life so much easier.

Thanks,
Elvis

[Tom61]

You need to make doubly sure that the card isn't CardBus, but a true PCCard/PCMCIA.

Then you need an adapter like this one, if the device can be powered by the Z:
http://cgi.ebay.com/ws/eBayISAPI.dll?ViewI...&category=48545

Or this one, if it needs more power through the PCMCIA connector than the Z can supply:
http://www.accurite.com/CFPCAdapter.html

There's some other caveat to using PCCards, but I can't remember it exactly. Something like being able to run in 12-bit mode?

[ElvisII]

Tom, thanks for the response.....


Card Spec:
ʉۢCompatible with Microsoft Windows and nearly all popular laptop PCs, equipped with Type II PCMCIA compliant 32-bit CardBus interface
•Card Type:
- Extended Type II PCMCIA compliant - 32-bit CardBus PC Card Interface



I take it the cardbus problem rules this out.

[arniel]

Tom, thanks for the response.....


Card Spec:
ʉۢCompatible with Microsoft Windows and nearly all popular laptop PCs, equipped with Type II PCMCIA compliant 32-bit CardBus interface
•Card Type:
- Extended Type II PCMCIA compliant - 32-bit CardBus PC Card Interface



I take it the cardbus problem rules this out.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=91826\"][{POST_SNAPBACK}][/a][/div]

Correct, it has to be a 16 bit PCMCIA type card.

[hubcapboy]

I'm no genius, but I fooled around with this for a while. I think I ran into power consumtion problems. I was trying to run a 5v lucent/orinoco/cabletron/att/whatever pcmcia card over an adaptor. I got the drivers to load, and read from the card, but never managed to enable it as a dev

/g

[drewsdad]

I'm no genius, but I fooled around with this for a while. I think I ran into power consumtion problems. I was trying to run a 5v lucent/orinoco/cabletron/att/whatever pcmcia card over an adaptor. I got the drivers to load, and read from the card, but never managed to enable it as a dev

/g
[div align=\"right\"][a href=\"index.php?act=findpost&pid=92060\"][{POST_SNAPBACK}][/a][/div]

It has to be an older card that is 16 bit and runs on 3.0 or 3.3 volts, the cf slot doesn't supply any more than that.