First I confirmed sticky keys were working. by testing it in a console.
Since I didn't find "-accessx" in startx, I tried this:
I edited this line in startx:
defaultserverargs=" +kb +accessx -screen 480x640@270"
to
defaultserverargs=" +kb -screen 480x640@270"
Then I moved /usr/X11R6/bin/ax to my hard drive.
When I shut down X (the GUI), I got these errors:
/usr/X11R6/bin/startx: line 177: unexpected EOF while looking for matching `"'
/usr/X11R6/bin/startx: line 186: syntex error: unexpected end of file
Then I tried to start startx, it didn't start immediately, so I hit the enter key again and the GUI started.
I went to a console and confirmed that sticky keys were no longer enabled.
Then I shut down X (GUI) again, and I could see the underlying messages on the screen that were output from the previous launch of startx.
The previous shutdown errors didn't occur this time.
I'm concerned about the (sticky keys) entry, since I disabled sticky keys (I think)
Model is SL-C3200
found pdaxii13.conf
- beep on resume is disabled
- default mplayer is mplayer-bvdd
... loading lightnpower settings
... loading spitz.xmodmap
... loading preset volume settings
... enabling xhost for loopback
... loading openbox
... accessx (sticky keys) enabled
... loading rox pinboard
... loading matchbox panel
X is running
EDIT:
I shut down X (GUI) again, (3rd time), and the above onscreen messages are the same for the last start of X (GUI)
It still has the ... accessx (sticky keys) enabled entry as above.
EDIT2 (final edit)
I rebooted and it booted into the GUI with no error messages, except the one we have talked about awhile back. (RFCOMM control, bla bla).
I had to shut down X (GUI) twice to view the underlying startx messages.
They are still the same as above with the (... accessx (sticky keys) enabled) line.
NOTE: after rebooting, X (GUI) started fairly quickly (as usual, I think)
Also, restarting X (GUI) twice, was nice and fast. (I think this is the same as it has always been in my installation of pdaxii13-akita)
Jon