Oz 3.5.3 On Boxer (c860)

[eklem]

Hmm, I did the same stupid mistake (cacko repartitioned c860 and then installing OZ). It handgs on the screen with the woman and the progress-bar. So I tried to go back to cacko, but then I get the following error before it tries to boot the faulty OZ (and hangs again). Here's the messages I get on screen:

[...]
modprobe: can't locate module devinfo
INIT: Entering runlevel 5

[new page]
Installer Starting
cannot detect tools package on /mnt/cf
error (1)
Rebooting
[...]


So, it seems I'm stuck for now. Anybody having any pointers on how to get something installed so I can repartition before I try to install OZ 3.5.3 again?

[lardman]

It looks like you're using the updater.sh from cacko (hence the req for the tools package), is this what you meant to do?

If so, it would appear you've forgotten the tools package (part of the cacko flash image download iirc). If you were trying to flash OZ, then use the updater.sh from the OZ feed.

Remember that the updater.sh files are pretty much all different.


Si

[eklem]

It looks like you're using the updater.sh from cacko (hence the req for the tools package), is this what you meant to do?

If so, it would appear you've forgotten the tools package (part of the cacko flash image download iirc). If you were trying to flash OZ, then use the updater.sh from the OZ feed.

Remember that the updater.sh files are pretty much all different.

Ahh, thanks. I wanted to go back to cacko to repartition, but had a little panic and just put the zImage.bin and not the whole tools.tar on the cf-card.