How Do You Like The 3200?

[MrStaypuft]

Sorry if these seems like a stupid question but what utility are you using to overclock your 3200?

I tried installing qtopia-combbatteryapplet_1.0.6_arm.ipk on my Zaurus but it would reboot after the install and then fail to come back up - the only way to get it going again was to do a restore from the boot menu.

[HoloVector]

ad hoc is available on the cacko c3200 and not in sharprom running c3200
[div align=\"right\"][a href=\"index.php?act=findpost&pid=149894\"][{POST_SNAPBACK}][/a][/div]

Thanks for clearing that up Cresho.

[HoloVector]

Sorry if these seems like a stupid question but what utility are you using to overclock your 3200?

I tried installing qtopia-combbatteryapplet_1.0.6_arm.ipk on my Zaurus but it would reboot after the install and then fail to come back up - the only way to get it going again was to do a restore from the boot menu.
[div align=\"right\"][a href=\"index.php?act=findpost&pid=149903\"][{POST_SNAPBACK}][/a][/div]

I'm using the combined battery overclocking applet that comes with Cacko 1.23.  I believe you need Tetsu's kernel to overclock under SharpROM so, that might be your problem.

[MrStaypuft]

I didn't believe there was a tetsu kernel for the 3200, which one did you install?

[HoloVector]

I didn't believe there was a tetsu kernel for the 3200, which one did you install?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=149913\"][{POST_SNAPBACK}][/a][/div]

There is 3200 specific one and it is at the same revision level as the the other 3x00 ones.  It is 18h.

I never installed it though, because my WiFi card needed HostAP drivers in order to work and I couldn't find them short of compiling them myself.  I couldn't compile my way out of a wet paper bag.  So I eventually gave up and switched to Cacko which has Tetsu-like kernel built-in.