Messages

1

Linux Issues / Sftp Over Usb Really Slow

« on: November 20, 2005, 01:33:00 pm »

So I got my stuff working and I can see the zaurus, ssh etc.  

Im using the OZ 3.5.2 rom, and the desktop is debian 3.1.

when I sftp to the zaurus and transfer files though, its transferring at like 4kb a second, granted its writing to either cf or sd, but still, thats pretty nasty.  wget d/l things way faster.

perhaps I will through the stuff on the web and wget it all....

2

Linux Issues / Debian + 5500, No Internet From Zaurus!

« on: November 18, 2005, 11:33:15 pm »

Ok so I have been following these how-to's to the t, perhaps i am forgetting something.

dmesg look slike this when I plug in the zaurus:
usb 1-2.2: new full speed USB device using address 13
usb0: register usbnet at usb-0000:00:02.0-2.2, Sharp Zaurus SL-5x00

ok, so its picking it up, then i run ifconfig:

ifconfig usb0 192.168.129.1 netmask 255.255.255.0 up
usb0      Link encap:Ethernet  HWaddr 36:A3:3B:A7:C8:E4
          inet addr:192.168.129.1  Bcast:192.168.129.255  Mask:255.255.255.0
          inet6 addr: fe80::34a3:3bff:fea7:c8e4/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:1098 errors:0 dropped:0 overruns:0 frame:0
          TX packets:1392 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:144629 (141.2 KiB)  TX bytes:132297 (129.1 KiB)

great, so i can ssh into the zaurus no problem, and i can ping my desktop (192.168.2.101) no  problem from the zaurus

So I am guessing it must have somethign to do with the masquearading / gateway.

here are the routing tables for the zaurus:

root@collie:~# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
192.168.129.1   *               255.255.255.255 UH    0      0        0 usbd0
192.168.129.0   *               255.255.255.0   U     0      0        0 usbd0
default         192.168.129.1   0.0.0.0         UG    0      0        0 usbd0

the default gateway takes like 10 seconds before it shows up, /etc/resolv.conf is set for the router, same as my desktop (192.168.2.1 the router)

I cant ping ip's or hostnames though from the zaurus, it just times out, nor can i ping the ip of the router.

anyone have any suggesstions / things I can try?

3

Angstrom & OpenZaurus / Oz 3.5.3 Wellenreiter Ii -- We V16/we V17

« on: April 23, 2005, 12:40:35 pm »

Was this ever fixed or updated in the feed?

4

Angstrom & OpenZaurus / Problems With Compat Libs

« on: April 21, 2005, 10:04:35 am »

So I have been scouring the forum before I made this post and didn't find much relative to my situation.

I have juts flashed my 5500 with 3.5.3, and when I try to install the sharp-compat-libs ( from what I gather formerly the oz-compat ipk) i get a failed dependency for opie-sh, so I install opei-sh, and then get a failed dependency for task-opie-minimum, I cant seem to find this guy though?


I have also had a separate issue where after a fresh flashing, it get errors about how I need to install libgcc1, isnt that base?

5

Windows Issues / Zaurus reboots when syncing?

« on: October 04, 2004, 09:24:34 am »

So I am runnins Sharp ROm 3.1 on a 5500 my laptop is running windows xp tablet edition.

When I hit sync on the cradle, or manually, intellisync opos up on my laptop, so I know communication is good.  Then when it starts "Preparing records" the zaurus goes to a black screen and says wait 5...4...3...2...1 and then enters runlevel 5 and reboots.  Weird!?!?!?!?  It seems to do this only when it is in the cradle, at least thats only when I have noticed it.  ANy ideas?

6

Angstrom & OpenZaurus / Syncing sl-5500 with Evolution via Multisync, help

« on: August 11, 2004, 01:25:42 pm »

Im on the same page with you, I have had things disappear from evolution, or recreated where I will have 2 appointments on one day, this has happened twice, so it waill say (work 8-5) 3 times in one day.  Makes me look real busy!  The only conclusion i have come to is the order of syncing.  If you set multisync to go from the zaurus to evolution it works fine.  But if you make a change in evolution and sync it with that setup, rather than setting up multisync to go from evolution to the zaurus, you get botched data and duplicate dates.  I am always a little cautios now when I sync, and have started syncing in 2 different places as a result.  Hope this helps, hopefully there is a better answer out there.

7

Angstrom & OpenZaurus / Web Browser for OZ

« on: July 09, 2004, 10:51:16 am »

I get the same problem, I get a bus error woth Konqueror, and Opera flashes for a sec looking like its going to work, then seg faults.

8

Angstrom & OpenZaurus / Konqueror and Opera Seg Fault

« on: July 07, 2004, 11:46:30 am »

I am having a slight problem here.  I have recently installed Konqueror and Opera from the ZUG feed to a ext2 formatted sd card.  There is around 16MB of space still left on the card, but both programs Seg Fault upon launch.  Anyone have ideas? Im running OZ 3.2

9

Angstrom & OpenZaurus / Want to upgrade to OZ, can I transfer my PIM data?

« on: July 05, 2004, 12:17:03 pm »

I am currently running the 3.10 Sharp Rom, and I would like to upgraide to OZ.  I have a ton of contacts and calendar data, and I was wondering if there is some way to back these up and then transfer them after I switch to OZ.  Any suggestions?

Kr5Kernel

10

Software / qtmail crashes after receiving a few messages

« on: June 22, 2004, 12:40:46 pm »

Sweet Jesus, this problem is resolved, The email server is Nat'd through a firewall, so I put the actual internal IP of the mail server rather than the hostname that routes to the firewall.  Next thing I know, I got 750 newly downloaded messages.  Who would have thought!!!!  Thanks for all your help!

11

Software / qtmail crashes after receiving a few messages

« on: June 22, 2004, 12:09:09 pm »

Oh Ya, I forgot to mention, I am connecting directly to the mail server with POP, I am syncing calendar and contacts from Evolution, but not syncing mail.

12

Software / qtmail crashes after receiving a few messages

« on: June 22, 2004, 12:07:33 pm »

Thanks for the link, but everything was in japanese on the site, and it looks like the ipk isnt there anymore.  I've tried search for the upgrade to no avail. Ug!

13

Software / qtmail crashes after receiving a few messages

« on: June 21, 2004, 08:45:44 am »

even after moving the files, and trying to run qtmail, it still craps out after recieving the 17th message.  the 18th message isn\'t irregular or anything.  I\'m all out of ideas.

14

Software / qtmail crashes after receiving a few messages

« on: June 18, 2004, 01:37:05 pm »

I reformatted the SD as ext2, and I moved all the files from /home/zaurus/Applications/dtm to a temp directory on the sd.  It still chokes on downloang after the 17th message.  Weird.  ANy other ideas?  Should I try reinstalling qtmail?  Is it possible without flashing?  Thanks for the help so far.

15

Software / qtmail crashes after receiving a few messages

« on: June 18, 2004, 10:43:57 am »

I also remvoed the link and put the dtm folder back on /home... still no luck.  I have like 300 messages....I don\'t get it.