Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - rmesek

Pages: [1]
1
General Discussion / Zaurus Goes For $2,247.00 On Ebay
« on: February 14, 2007, 03:55:10 pm »
Am I missing something or what? I think this was a used 3200. Couldn't one buy this for much less new?

2
6000 - Tosa / No Sl6000 Display
« on: January 27, 2007, 09:34:53 pm »
When I turn on my 6000, the display is black. This happened after a week of low battery warnings even though I had it on the charger, and after I dropped it. I tried taking the battery out for a while and reinserting it; hard resetting it with reset while haolding the OK butteon; holding Q and T while resetting. I tried removing the battery overnight, then pressing D and B and plugging in the power; also, holding Fn, D, and M while pressing reset. The charging light comes on and something beeps when I did a hard reset. The display seems to change to a different shade of black when I try to trun it on but nothing that I can use.

Did I do damage to the screen when I dropped it or is it a used-up battery? I had its Piel Frama case on when dropped and I've dropped it before without a problem. If it's the screen, what can I do to repair it? If it's just the battery, I can replace it.

Help.

3
How do you stretch wallpaper so it doesn't tile? I've got 480x640 jpg's and they tile when I set them as wallpaper in both landscape and portrait. I have an sl6000. I'm certain there must be an easy and obvious way to do this and think I've done it in the past, but can't figure this out right now.

4
Angstrom & OpenZaurus / Problem Flashing Oz-opie On Sl6000
« on: January 30, 2006, 05:12:32 pm »
I tried to flash OZ-OPIE to my sl6000, went through the procedure documented on this site with the maintainance menu, get the console messages that it is flashing the image files, reset, and then try to format it through the maintainance menu. At this point the screen goes blank and the power light goes off. I can do nothing or see nothing going on until I do a reset again. I tried restoring a fresh stock NAND on an SD card but the same thing happens. Don't tell me a made a brick please! What can I do?

Pages: [1]