C1000 Cross-compiler Setup...

[Ragnorok]

- I've finally gotten an usable (as in new enough hardware for noticable performance) Linux installation so I can set up for compilation for the C1000.  I have an old (glacially slow) Linux setup for compiling for the SL-5500.  If I use the same setup (install files, environment, configuration, etc) I used for the SL-5500, will it work on the C1000?  It doesn't *seem* like it should.
- I searched this forum for "C1000" and found not a single post.  So I searched the parent for "C1000" and found one post, but that guy appears to be doing local compilation (directly on the Z) instead of cross-compiling on Linux.  It may be in another forum, but "Everything Development" sure seemed like the obvious place to look!!  (cheshire grin)
- Any clues out there?  Thanks for your time...

[kahm]

It's all still Qtopia 1.5.4, so your old environment should still work. I've use the old tools and instructions to compile for the 860...

[Ragnorok]

- Wouldn't the virtual framebuffer geometry be wrong?  Or is that configurable?  Guess I should try it and see, huh?  (drool)  The other hardware is soooooo sllllooooowwww that I haven't touched it in months and months.
- Basically just trolling for caveats and whatnot.  Thanks for your time...

[lpotter]

- Wouldn't the virtual framebuffer geometry be wrong?  Or is that configurable?  Guess I should try it and see, huh?  (drool)  The other hardware is soooooo sllllooooowwww that I haven't touched it in months and months.
- Basically just trolling for caveats and whatnot.  Thanks for your time...
[div align=\"right\"][{POST_SNAPBACK}][/a][/div]

[a href=\"http://www.qtopia.net/modules/developers/]Qtopia.net[/url]

[Ragnorok]

- Thanks for the hand holding!  Shouldn't have *needed* it, but thanks!