It would help if you gave some more information than "can't get monitor or scanning to work at all". Any error message? Any steps to reproduce the problem?
[div align=\"right\"][a href=\"index.php?act=findpost&pid=86177\"][{POST_SNAPBACK}][/a][/div]
I load Wellenreiter. "Can't set interface 'eth0' into monitor mode: Invalid argument Continue with limited functionality?"
The "Rescan Neighbourhood" function in Wireless Configuration does not do anything.
ifconfig:
eth0 Link encap:Ethernet HWaddr 00:A0:F8:A0:5C:46
inet addr:192.168.2.206 Bcast:192.168.2.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:37 errors:0 dropped:0 overruns:0 frame:0
TX packets:37 errors:1 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:4835 (4.7 KiB) TX bytes:7611 (7.4 KiB)
Interrupt:135
iwconfig:
eth0 IEEE 802.11-DS ESSID:"werd" Nickname:"Prism I"
Mode:Managed Frequency:2.437 GHz Access Point: 0B:16:13:B1:31:38
Bit Rate:11 Mb/s Tx-Power=15 dBm
Retry limit:16 RTS thr:off Fragment thr=0 B
Encryption key:92B4-G324-F1AB-1170-B355-2319-62 Security mode:open
Power Management:off
Link Quality=28/92 Signal level=135/153 Noise level=107/153
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
Also, if I take the CF card out and put it back in, it creates an eth0 and then puts the network card at eth1. If I do it again it will up the number again. I hope this is helpful.
