Wcf12 - Connected, But Not....

[ThreeDot]

Stock Zaurus SL-5500 (latest Sharp ROM)
Linksys WCF12
Native Drivers
Wireless IP: 192.168.1.108
USB IP: 192.168.129.201
Gateway (for WiFi) set to ip of router (1.1)



Ok, here it is in a nutshell:

I plug in the card (comes up as eth0), connect to my wireless network (to all indications successfully), I can ping localhost, I can ping the ip (192.168.1.108) but I can't ping anything else on the network, not even the gateway...



Ifconfig:

eth0      Link encap:Ethernet  HWaddr 00:0C:41:15:BC:24
          inet addr:192.168.1.108  Bcast:192.168.1.255  Mask:255.255.255.0
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:94 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:100
          RX bytes:0 (0.0 B)  TX bytes:2016 (1.9 Kb)
          Interrupt:35


netstat -rn:

Kernel IP routing table
Destination     Gateway         Genmask         Flags   MSS Window  irtt Iface
192.168.129.0   0.0.0.0         255.255.255.0   U        40 0          0 usbd0
192.168.1.0     0.0.0.0         255.255.255.0   U        40 0          0 eth0
0.0.0.0         192.168.1.1     0.0.0.0         UG       40 0          0 eth0

HELP!

[russilwvong]

I plug in the card (comes up as eth0), connect to my wireless network (to all indications successfully), I can ping localhost, I can ping the ip (192.168.1.108) but I can't ping anything else on the network, not even the gateway...

What do "iwconfig eth0" and "lsmod" say? I just went through the process of getting a different Wifi CF card running:
https://www.oesf.org/forums/index.php?showtopic=14812

[ThreeDot]

What do "iwconfig eth0" and "lsmod" say? I just went through the process of getting a different Wifi CF card running:
https://www.oesf.org/forums/index.php?showtopic=14812
[div align=\"right\"][a href=\"index.php?act=findpost&pid=96069\"][{POST_SNAPBACK}][/a][/div]

iwconfig eth0:

eth0      no wireless extensions.

---I assume this is a problem, but what do I do about it?  This is driving me nuts...

lsmod:

Module                  Size  Used by
sa1100_bi              23088   0  (unused)
net_fd                 16688   1
usbdcore               22592   0  [sa1100_bi net_fd]
usbdmonitor             5488   0
prism2_cs              54576   1
p80211                  9952   1  [prism2_cs]
sharp_mmcsd_m          27408   1
devinfo                 2912   0  (unused)

[lardman]

prism2_cs?

Uses hostap here. Is this a funny feature of the Sharp 'ROM's?


Si