Anybody Compile Flite Or Roadmap For 3.5.1?

[ninsei]

not in the feed and i think they're both affected by the floating point thing.

[Shdwdrgn]

For what it's worth, I have been unable to get roadmap to work under either opie or gpe 3.5.1.  I have not yet tried to compile my own package though.

RoadGPS however did partially work under opie using the compat lib, however due to the math problems, it was unable to calculate the GPS positions.

[MrSquishy]

I've got zRoadMap running on my 5500/3.5.1 without any problems.
I dont have a GPS, so I have no idea if a reading from it would be accurate.

I attached zroadmap_1.0-2_arm.ipk (because I dont remember where I got it) to this post, you'll need your usc#####.rdm's as well as usdir.rdm otherwise it wont run.

[Hrw]

zroadmap 1.0.8 is available in OZ 3.5.2: feed/opie/

[dino]

I just downloaded flite from the 3.5.2 feed.   It does work with 3.5.2.

[drewb]

I've gotten zroadmap to work under 3.5.2, but have had no luck with qpeGPS.  That and opieMail are the killer apps for me.  I'll be leaving for SE-Asia tomorrow morning and was trying to get my old SL-5500 up to snuff before leaving.

OpieMail is doing great.  It talks SSL to my imap server and TLS to  my smtp server.  Wonderful.  

qpeGPS shows promise, but I can't install the build on SF.net, and the build in the 3.5.2 feed doesn't work with gpsd from the 3.5.2 feed.  I would have liked to rebuild w/ debugging, but I struggled to get a working toolchain (openembedded being down limits me to a very small set of resources).

Does anyone have a build box I could get an account on?  There are reports of qpeGPS 0.9.2.1 working well, but, like I said, the ipks on sf.net are fubar'd.

--
Drew

[Oriumpor]

I've been trying to get Flite to run in 3.5.1 or 3.5.2 on my SL5000d and for the life of me I can't figure it out.  It looks like the installation keeps filling up my rootfs after a clean flashing and installing it to /var or my sd doesn't seem to work at all.   I've tried OZ 3.5.1 and 3.5.2 with both zImages  (24/8 and 32/0)  to no avail.

I was perfectly happy with the self contained binary of flite, this lib install is just a pain in my rear.

[adf]

does the binary not work in OZ?  even with compatlibs?