Author Topic: Oz 3.5.2 - Back To The Sharp Image (Read 2206 times)

amitgil · « **on:** December 03, 2004, 12:10:42 pm »

Hi,

I Loaded OZ 3.5.2 into my SL6000, and have a few questions:

- With the Sharp image I could enter the diagnostic mode using power+D+M. I can't do that with the OZ image. Anyway I can have that with OZ? How can I reflash back to the Sharp image. I have it backed on the CF.

- The power button doesn't suspend the device. I think that I saw somewhere a post on that, but couldn't find it. How can I get it to work. Same problem with the rotate button.

Thanks,
Amit.

freshroastedpeanut · « **Reply #1 on:** December 03, 2004, 02:48:06 pm »

For diagnostic mode on the 6000, try reset+d+p.

Power button does not work, on 3.5.1 it would set you up into an infinite reboot loop, so it looks like it was disabled in 3.5.2/ Either use the menu or just let it sit for a miute- it will suspend on its' own.

amitgil · « **Reply #2 on:** December 03, 2004, 05:04:15 pm »

Tried reset, then Power+D+P, same results. Is that tehe correct sequence? Seems a bit hard to get back to the original image :-(

Thanks,
Amit.

amitgil · « **Reply #3 on:** December 03, 2004, 05:45:06 pm »

Ignore the previous post, I got it. Thanks.

Amit.

Pyrates · « **Reply #4 on:** December 04, 2004, 05:34:16 am »

Then, how about sharing the solution to your problem?

Cheers
Philipp

News:

Author Topic: Oz 3.5.2 - Back To The Sharp Image (Read 2206 times)